Collinite No.100 Beadcoat Ceramic + Graphene Spray Sealant 

Collinites No.100 Beadcoat Ceramic + Graphene Spray Sealant promises great water beads, gloss, and durable protection in a fast, easy to use product. This high gloss, super slick finish is easily applied to a variety of automotive exterior surfaces. Featuring an Sio2+graphene resin structure, this all new formula from Collinite provides 6+ months of protection to paint, ppf, trim, and more. Boasting both high UV resistance, and detergent resistance, BEADCOAT is simple to apply and provides a shine that lasts! Beadcoat can also be used to enhance & preserve an existing ceramic coating or paint protection film when utilized as a topper or for maintenance. Safe for paint, glass, wheels & trim.

Features:

• Easy wipe on / wipe off high gloss shine.
• Hydrophobic beading effect.
• Use as stand alone sealant or applied over your favorite ceramic coatings.
• UV and detergent resistant.
• 6+ months paint protection.
• Average spread/coverage: 600-1,000 sq ft.
• Pleasantly scented.

Directions:

• Always test product first in a small, inconspicuous area to ensure desired result.
• Shake well before each use.
• For optimal bond/protection, ensure surface is free of above-surface contamination; this can be achieved with IronX + clay process (towel or bar). Below-surface paint imperfections (swirls/ scratches/marring) should be removed by DA Polish (e.g. OBSSSSD Paint Clean).

1. Apply 2-3 sprays of Beadcoat directly onto a 3 x 3 ft panel.
2. Using a Microfiber Madness Slogger Towel or any low nap quality microfiber towel, work the product into the paint evenly until almost flashed away.  
3. Switch to a fresh clean towel (we prefer the Crazy Pile Towel). Buff the area once more to be sure no residue remains.
4. Check after each panel before moving to next.

Applying by microfiber applicator:

1. First, spray microfiber applicator twice with product to moisten/prime.
2. Next, apply 2-3 sprays of Beadcoat directly onto a 3 x 3 ft panel.
3. Spread evenly in a cross natch, uniform pattern.
4. Immediately remove with dry, clean microfiber towel.
5. Flip removal towel and change as necessary to avoid streaks.
6. Avoid applying to hot surfaces.
7. For optimal bond/protection/slickness - allow at least 24 hour cure time before introducing water to surface.

Wet Application: (*This process is only recommended if a previous base coat of Beadcoat has been applied*):

1. Following a wash-while vehicle surface is still wet-apply 2 sprays of Beadcoat to one 3×3 ft panel at a time.
2. Using a microfiber towel, wipe entirety of panel until dry.
3. Flip towel as necessary, and change towels as they become saturated.
4. Repeat process on all painted surfaces (and glass). 

Not intended for:

• Hot surfaces.
• Applying over waxes and sealants.
  
• Removal of surface defects (swirls, scratches).
• Not for use on contaminated surfaces; untreated by iron (chemical) or clay (mechanical) processes.
• Interior surfaces.
• Tires.